33
8. Connect the red core(s) to the terminal socket marked “+”and the black
core(s) to the terminal socket marked “-”. The terminal clamps are operated
using a screwdriver as shown in the inset diagram.
9. Using the tie-wrap fitting on the pedestal lid, secure the cable.
CAUTION:
Do not grease the seal in the pedestal lid.
10. Check the seal in the pedestal lid is correctly seated.
Grease the four self-retaining case bolts and thread holes with Denso paste
(supplied).
Close the pedestal lid, ensuring that the cable does not become trapped and
that the seal is not pushed-out at the front of the pedestal: it will help if you
support the front of the lid (by holding the mounting bracket) as you lower the
rear of the lid.
11. Tighten the four self-retaining bolts to 12 Nm (8.8 lb ft.).
Tighten the cable gland nut 1/2 turn.
2
1
Grey
Purple
Blue
Green
Yellow
Orange
Coaxial Screen
(Black)
Coaxial Inner
(White)
Signal connector
D6276-1
To Next Page
Loading...
