Raymarine SeaTalk Joystick - User Manual

1
Document Number 81227-2
June 2005
Raymarine SeaTalk Joystick
Introduction
Thank you for choosing Raymarine.This booklet contains installation, calibration
and operation instructions for your Joystick. To get the best from your product,
please take time to read these before use.
Autopilot Compatibility
The SeaTalk Joystick is compatible with Raymarine SmartPilots and Course
Computers with software version 3 or later. Use the procedures in the
maintenance chapter of the Autopilot Operating Guide to find out the software
version on your system. If you have pre-version 3 software, contact your local
Raymarine dealer for assistance.
Warranty
To register your new Raymarine product, please take a few minutes to fill out the
warranty card. It is important that you complete the owner information and
return the card to us to receive full warranty benefits.
83 mm (3.27 in)
88 mm (3.5 in)
110 mm (4.33 in) 110 mm (4.33 in)
D6413-1
51 mm (2 in)
219 mm (8.6 in)
152 mm (6 in)
81227_2.book Page 1 Wednesday, November 2, 2005 10:51 AM

Summary

Joystick Operation

Basic Operation

Explains how to engage joystick control and interpret the autopilot display.

Normal Proportional Mode

Describes proportional mode where rudder application is proportional to joystick movement.

Bang-Bang Mode Operation

Applying Port Rudder

Details bang-bang mode for continuous rudder drive when applying port rudder.

Applying Starboard Rudder

Details bang-bang mode for continuous rudder drive when applying starboard rudder.

Installation Overview

System Connection Diagram

Step 1: Mounting the Joystick

Step 2: Mounting the Joystick Pod

Step 3: Wiring the Joystick Pod

Step 4: Connecting to SeaTalk Network

Setting up Your Joystick

Operating Mode Selection

Raymarine SeaTalk Joystick Specifications