Chapter 3: Installation 15
SeaTalk
CAUTION: Using the wrong type of pod could cause damage to your
equipment. Before you connect a transducer to a pod, ensure that you are
using the correct type of pod (speed pod for a speed transducer or depth
pod for a depth transducer, for example).
• Fit the appropriate transducer directly to its corresponding instrument as shown.
Pod connectors are color-coded. Ensure that each wire is connected to its
corresponding connector.
3.3 Final fix
• Ensure the controller is mounted securely.
3.4 Commission the instrument
The instrument must be commissioned before you use. For new systems this involves
calibrating the instrument, which is a safety-critical action. Refer to the ST70
Instrument Reference Manual for instructions.
D10418-1
Speed
transducer
ST60+ speed instrument ST70 instrument
To Next Page
Loading...