- 02 -
Chapter 2 OUTLET POWERED & BATTERY BACKUP
Chapter 3 TIME SETTING
- 01 -
Chapter 1 PRODUCT DIAGRAM
1. FM & Bluetooth Mode
2. Play & Scan
3. Previous & Hour
4. Next & Minute
5. Volume Down
6. Volume Up
7. Dimmer & DST
8. Store & Pair
9. Recall & Sleep
10. Time & 12/24H
11. Set Alarm
12. Alarm ON/OFF
13. Snooze & Night Light
14. Display
15. Radio Antenna
16. Speaker
17. Type C Charging Port
18. USB Charging Port
19. DC IN Port
CR1002
FM & BLUETOOTH Clock Radio
CREATE A PERFECT SLEEP ENVIRONMENT
Contact our experts
support@raynic.com
Version 1.3
Mad e in PRC
https://www.raynic.com
7 8 9 10
PAIR
STORE
SLEEP
RECALL
12/24H
TIME
SET
ALARM
ON/OFF
ALARM
DST
DIMMER
VOL-HOUR MIN VOL+SCANMODE
FM
1 2 3 4 5 6
11 12
13
14
15
16
17 18
19
1. Pull the insulator out of battery compartment to activate Cr2032 as
backup battery.
NOTE: Backup battery(included) doesn't support time display, only support back up
Time & Alarm setting.
2. Connect the adapter to DC jack , then plug into a 100~240V AC wall power
outlet.
1. Press button once, display starts flashing.
2. Press button to set the hour and
press button to set the minute.
3. Press button to save time or wait for another 10 seconds to
confirm automatically.
4.Hold press button to change 12H/24H time format.
PAIR
STORE
SLEEP
RECALL
12/24H
TIME
SET
ALARM
ON/OFF
ALARM
DST
DIMMER
VOL-HOUR MIN VOL+SCANMODE
FM
HOUR
MIN
12/24H
TIME
12/24H
TIME
12/24H
TIME
Buttons Parts
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
(1)this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Statement
To Next Page
Need help?
General