Raytech TR-1P - Page 4

KEEP AWAY FROM LIVE CIRCUITS
Operating personnel must not remove instrument covers. Component
replacement and internal adjustments must be made by qualified service
personnel. Do not replace components with power cable connected. To
avoid injuries, always disconnect power, discharge circuits, and remove
external voltage sources before touching components.
DO NOT SUBSTITUTE PARTS OR MODIFY INSTRUMENT
Because of the danger of introducing additional hazards, do not install
substitute parts or perform any unauthorized modification to the
instrument. Return the instrument to a Raytech Switzerland service
department for service to ensure proper operation and that safety features
are maintained.
Instruments, which appear damaged or defective, should be made
inoperative and secured against unintended operation until they can be
repaired by qualified service personnel.
UNCRATING: 2 – 0
Unpack your new TR-1 or TR-1P and check to see that you have the
following items:
TR-1 H & X Manual Carry Case
or leads
TR-1P
If any of the above items are missing or damaged contact your local
representative or Raytech Switzerland immediately.
The TR-1 & TR-1P field case is a waterproof design with an automatic
pressure relief valve.
All rights reserved. No portion may be reproduced without written consent
3 RAYTECH Switzerland