To Next PageTo Next Page
Need help?Do you have a question about the Raytheon 138-118 and is the answer not in the manual?
General| Brand | Raytheon |
|---|---|
| Model | 138-118 |
| Category | Power distribution unit |
| Language | English |
Explains the CAN bus network architecture, addressing, and termination requirements for device communication.
Details electrical supply, current, input, and output interfaces of the distribution unit.
Identifies LEDs, push buttons, jumpers, and connectors on the distribution unit's interface PCB.
Provides instructions on stripping cables, preparing shielding, and making general connections for system installation.
Details the process for creating common earth references for EMC compliance and system integrity.
Covers physical mounting of the unit and installation of optional accessories like the AC/DC-Converter.
General notes on making connections according to drawings and considering cable diameters.
Describes the function of jumpers B31 and B32 in activating CAN bus terminators for network integrity.
Guides on using DIP-Switch B20 and push buttons B22/B23 for mode selection and setting.
Procedure for assigning unique CAN bus addresses to devices to avoid conflicts.
Explains how to set output channels to Course bus, NMEA1, or NMEA2 interfaces.
Detailed steps for calibrating the magnetic sonde using test points and potentiometers.
Displays uncorrected heading data for Gyro compasses 1, 2, and 3 via DIP switch settings.
Shows magnetic compass heading, variation, and deviation values as adjusted by DIP switches.
Guides on setting NMEA telegram requests and interpreting received NMEA data strings.
Displays software versions for the CAN-bus processor and the I/O-PCB of the distribution unit.
