Owner manual
1. Adjust the angle of the handlebar.
You will find 4 hex bolts attaching your
stem. Use an M5 allen key (or an M6
allen key depending on your version) to
loosen them. Once loosened, position
the handlebar angle to your liking and
retighten the stem bolts.
2. Adjust the height of the
handlebar. You will find a hex bolt on
top of the stem (it may be covered by a
plastic cap), and two bolts on the side of
it. Use an M5 allen key (or an M6 allen
key depending on your bike version)
to loosen them. Once loosened, pull
the complete handlebar upwards, then
place each three stem spacers over or
under the stem to adjust the handlebar
height. Retighten all the bolts.
The correct handlebar height can
avoid discomfort and prevent injuries,
especially when the bicycle is used for
hours.
ADJUST
OPEN
ADJUST
To Next Page
Loading...
