Owner manual
1. Place the front light on the fork crown screw
holes. Use an M5 allen key to tighten the screws. Tighten
both of them until the front light is firmly seated.
3. Open the tank and locate the front light wire.
Identify the front light cable by its two-pin red plug. Consult
the section “05 Electrical maintenance” in this manual to
identify all the cables.
4. Pass the cable into the tank. Pass the cable through
the front side of the tank. Once inside, plug it with its
connector.
5. Close the tank and check. Make sure everything is
properly connected and inside the tank. Start the bike and
check if the lights work by pressing the light button on the
throttle. Press it again to turn it off.
To Next Page
Loading...
