Owner manual
1. Take the saddle off. Consult the section “Saddle
adjustment” in this manual for more information if needed.
2. Remove the spring nuts and spacers. Use the 10
mm wrench to remove both spring nuts and separate the
springs from the saddle. Remove the spacers too.
3. Place the rear light. Put the rear light plate through
the holes and reattach the spacers, springs and nuts.
Bend the metal plate of the light for a better adjustment if
needed. Make sure the light cable goes between the saddle
and the metal bars to the front.
4. Place the saddle back. Place back the saddle and
adjust it to your height.
5. Open the tank and locate the rear light wire.
Identify the rear light cable by its six-pin black plug. Consult
the section “05 Electrical maintenance” in this manual to
identify all the cables.
6. Pass the cable into the tank. Pass the cable through
the left back side of the tank. Once inside, plug it with its
connector. Fix the cable to the frame with a cable tie.
7. Close the tank and check. Make sure everything is
properly connected and inside the tank. Start the bike and
check if the lights work by pressing the light button on the
throttle. Press it again to turn it off.
To Next Page
Loading...
