HEADLINE
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
3
BEFORE YOU BEGIN
3
Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping.
Because the Rambler 12 is 95 percent assembled and packed at the factory, there should not be any problems, even if
the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 15 minutes for assembly.
Allow up to 12 hours for initial charge (see page 5 for charging information).
2.
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR RAZOR RAMBLER 12. The
Rambler 12 has been built to certain
Razor design specifications. The
original equipment supplied at the
time of sale was selected on the
basis of its compatibility with the
frame, fork and all other parts.
Certain aftermarket products may
not be compatible and will void
your warranty.
Product ID Locations:
(See locations to the left)
1. Back of Frame
2. Charger
3. Battery Cover
4. UPC Side of Box (not shown)
6 mm Allen Wrench (included)
Required Tool
Throttle
Brake Lever
Fork
On/Off
Switch
Charger
Port
3.
1.
Kickstand
Plastic Bag Contents:
• Charger
• Tool
• Owner’s Manual
Charger
Note: Charger design may
vary from one shown
To Next Page
Loading...