HEADLINE
4
ASSEMBLY AND SET-UP
4
Attaching the Handlebars
Required Tool: 6 mm Allen Wrench
Attaching the Front Fender
Required Tools: 5 mm Allen Wrench and 10 mm Wrench
Attaching the Number Plate
1 Place the handlebars in the
handlebar clamps.
1 Align fender with the hole in the
fork and insert the bolt. Tighten
securely using a 10 mm wrench and
5 mm Allen wrench.
1 Slip the cables through the slit on
the top of the number plate. Align
the holes on the fork and snap on the
number plate.
2 Align parallel to the fork and
tighten the bolts using a 6 mm Allen
wrench. When properly tightened,
the handlebars should not move
forward or backward.
WARNING:
Failing to properly adjust and
tighten the bolts that affix the
handlebars can cause you to lose
control and crash.
To Next Page
Loading...
