REPAIR AND MAINTENANCE
Battery Care and Disposal
Never store the product in freezing or below freezing temperatures! Freezing will permanently damage the battery.
Failure to recharge the battery at least once a month may result in a battery that will no longer accept a charge.
Pb
CONTAINS SEALED LEAD ACID BATTERIES. BATTERIES MUST BE RECYCLED.
Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an
environmentally safe manner. Do not dispose of a lead-acid battery in a fire; the battery may explode or leak. Do not
dispose of a lead-acid battery in your regular household trash. The incineration, land filling or mixing of sealed lead-acid
batteries with household trash is prohibited by law in most areas. Return exhausted batteries to a federal or state
approved lead-acid battery recycler or a local seller of automotive batteries. If you live in Florida or Minnesota, it is
prohibited by law to throw away lead-acid batteries in the municipal waste stream.
Charger
The charger supplied with the electric scooter should be regularly examined for damage to the cord, plug, enclosure and
other parts, and in the event of such damage, the product must not be charged until it has been repaired or replaced.
Use ONLY with the recommended charger.
Wheels
Wheels and drive system are subject to normal wear and tear. It is the responsibility of the user to periodically inspect
wheels for excess wear and adjust and replace drive train components as required.
Replacement Parts
The most frequently requested replacement parts are available for purchase at some Razor retail partners.
For the complete selection of replacement parts visit shop.razor.com.
Repair Centers
For a list of authorized Razor repair centers:
• Check online at www.razor.com.
• Additional Customer Service contact information is listed on the back of this manual.
WARNING: If a battery
leak develops, avoid contact with
the leaking acid and place the
damaged battery in a plastic bag.
Refer to the disposal instructions at
left. If acid comes into contact with
skin or eyes, flush with cool water
for at least 15 minutes and contact
a physician.
WARNING: Battery
posts, terminals and related
accessories contain lead and
lead compounds. Wash your
hands after handling.
4 Remove wheel and install
replacement wheel. (Note the
sequence of the hardware.)
5 Push the chain tensioner
down to install the chain on both
sprockets.
6 With two (2) 13 mm wrenches,
re-tighten the locknuts.
Note: Rear wheel hardware
sequence
Right Side (Throttle)
18-1 13 mm Locknut
18-7 Spring Washer
18-2 Washer
Frame
18-3 Washer (Plate Cut)
18-4 Spacer (Short)
Left Side (Brake)
18-1 13 mm Locknut
18-7 Spring Washer
18-2 Washer
Frame
18-3 Washer (Plate Cut)
18-4 Spacer (Long)
7 Reattach the chain guard.
Middle
18-8 Rear Axle Bolt
To Next Page
Loading...
Need help?
General
