Calibration Confirmation
Note: Your Hovertrax 2.0 should have been calibrated at the factory.
1 Place Hovertrax 2.0 on a level surface.
2 Turn power ON. If product remains level or adjusts to become
level, calibration has been confirmed. No further steps are needed.
If product begins to roll or does not move into a level orientation,
see Calibrating Hovertrax 2.0 on page 2.
Need Help? Visit our web site at www.razor.com or call 1800 244 543 or email:
info@funtastic.com.au Monday - Friday 9:00 AM - 5:30 PM.
HOVERTRAX 2.0/DLX 2.0
CALIBRATION INSTRUCTIONS
1
To Next Page
