4
Battery Power
Level Indicator
Rubber Tires
Balance Level
Indicator
On/Off Switch
Charge Port
Anti-Slip Foot Platforms
2.
WARNING:
DO NOT USE NON-RAZOR PARTS
WITH YOUR PRODUCT.
The Hovertrax has been built to
certain Razor design specifications.
The original equipment supplied
at the time of sale was selected
on the basis of its compatibility
with the frame and all other parts.
Certain aftermarket components
may not be compatible and will
void the warranty.
Product ID Locations:
See locations to the left
1. Frame (Underneath Unit)
2. Charger
3. Box - Side of UPC (Not Shown)
Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping.
Because the Hovertrax was assembled and packed at the factory, there should not be any problems, even if the box has
a few scars or dents. Please keep this box in case you need to send the Hovertrax back for service or repairs. If you use
another box, Razor will not be responsible for any damage caused during shipping.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY MAINTENANCE PROCEDURES.
Estimated Set-Up Time
Allow up to 6 hours for initial charge (see page 5 for charging information).
BEFORE YOU BEGIN
Charger
(Note: Charger design may
vary from one shown)
Box Contents:
• Hovertrax
• Charger
• Owner’s Manual
To Next Page
Loading...
Need help?
General
