1 Using a Phillips screwdriver remove the six (6)
screws and remove the deck plate.
(Note: There are two (2) sizes of screws,
A-Small, B-Large)
2 Using a Phillips screwdriver remove
the battery strap.
3 Disconnect the battery wire connector from the
control module and carefully remove the battery.
Note: If only replacing battery, install new battery
and reverse steps 1-3.
4 Disconnect the motor wire connector from the
control module.
8-2 8-4 8-4 8-2
8-1 8-18-3 8-38-5
6
REPAIR AND MAINTENANCE
Note: Rear wheel/motor
hardware sequence
Left Side
14-1 Phillips Screws (3)
14-2 Motor Housing
Right Side
14-3 Spacer
14-4 Nut
Frame
14-5 Flat Washer
14-6 Lock-Washer
14-7 Locknut
Right Side (Throttle)
8-4 Spacer
8-3 Washer
8-2 Spring Washer
8-1 M10 locknut
Middle
8-5 Front axle bolt
Left Side (Brake)
8-4 Spacer
8-3 Washer
8-2 Spring Washer
8-1 M10 locknut
1 Using two (2) 16 mm wrenches, loosen the axle bolt.
Remove wheel and install replacement wheel.
(Note the sequence of the hardware)
q Front Tire Replacement
Tools Required: Two (2) 16 mm Wrenches
Note: Front wheel
hardware sequence
q Rear Wheel/Hub Motor/Battery Replacement
Tools Required: Phillips Screwdriver and Two (2) 13 mm Wrenches
(Battery Replacement Steps 1-3)
To Next Page
Loading...
