ASSEMBLY AND SET-UP
4
Adjusting the Brake
Required Tools: 3 mm Allen Wrench and 8 mm Allen Wrench
1 To adjust the brake cable wire,
thread the brake lever adjuster in or
out 1/4 to 1/2 turn until the desired
cable tension is attained.
2 Squeeze the brake lever to test
the brake to make sure it is working
properly. The front fender should
clamp down and rub against the
front wheel. If brake is not working
properly, proceed to the next step.
3 If the brake is too tight or too
loose, use a 8 mm wrench and
a 3 mm Allen wrench to adjust
as needed.
To Next Page
Loading...
