Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
4
HEADLIN EREPAIR AND MAINTENANCE
CLEANING YOUR RIPSTIK
WHEELS AND BEARINGS
Wipe with a damp cloth to remove dirt and dust.
Do not use industrial cleaners or solvents as they may damage the surfaces. Do not use alcohol, alcohol-based or ammonia-based cleaners as they may
damage or dissolve the plastic components.
Under normal circumstances and conditions, RipStik Ripster wheels and wheel bearings are maintenance free. Nonetheless, it is the responsibility of the
owner or guardian to periodically inspect the wheels for wear and tear, the axle for proper tightness, and the bearings for side-to-side play and loose parts.
When a wheel or wheel bearing develops play, this is an indication of excess wear and replacement is necessary. Replace immediately with only genuine
RipStik Ripster wheels. Worn wheels/bearings are considered normal wear-and-tear and are not covered by the RipStik Ripster Limited Warranty. Wheels
other than genuine RipStik Ripster wheels may not be compatible with your RipStik Ripster caster board. The use of anything other than genuine Razor
replacement parts will void your warranty.
Replacing the Batteries (continued)
Required Tool: Phillips screwdriver (not included)
WARNING:
• AA batteries included for lights -
adult attention for changing
and disposal.
• Batteries should only be replaced
by an adult.
• Loose batteries could present
a choking hazard and should be
kept away from small children.
• Do not mix old and new batteries.
• Do not mix alkaline, standard
(carbon-zinc) or rechargeable
(ni-cad, ni-mh, etc.) batteries.
• Dispose of batteries properly.
Note: Batteries are not covered
under the Limited Warranty.
4 Insert the new AA batteries and replace the cover
and four (4) screws using a Phillips screwdriver.
Note: When installing the batteries, please pay
attention to the batteries’ positive and negative
side which must align with the positive and negative
markings in the battery housing.
3 Discard the old batteries.
To Next Page
Loading...
