3
HOW TO OPERATE LIGHTS
Activating Lights
• There is no power switch to activate the lights on the deck.
• The lights are activated by a vibration sensor.
• Lights are activated when product is in motion.
• Lights will remain on for approximately 20 seconds after product has stopped moving. Lights are re-activated when product resumes motion. There are
total of 5 modes that can be selected.
Switching Light Modes
• Press the button at bottom of the rear deck platform to switch lights to the next mode. There are total of five (5) light modes than can be activated.
3
CHECK BEFORE RIDING
Always inspect your caster board’s wheel bearings and other hardware to make sure they are tight before each use.
REPAIR AND MAINTENANCE
Replacing the Batteries
Required Tool: Phillips screwdriver (not included)
1 Using a Phillips screwdriver, remove the four (4)
screws from the battery cover.
2 Remove the battery cover and set aside.
To Next Page
Loading...
