What to do if there is no sound from my RBH Sound Subwoofer?
If your RBH Sound Subwoofer isn't producing any sound, first, ensure the amplifier is plugged into an unswitched AC power outlet. Second, verify that the amplifier is receiving an audio signal from the receiver or processor. Lastly, check the amplifier fuse and replace it if necessary. If the fuse isn't easily accessible, contact your authorized RBH Sound dealer.
Why is my RBH Sound performance less than expected?
If your RBH Sound Subwoofer's performance is less than expected, check the entire system for proper polarity by ensuring the + and - polarity of the subwoofer wire is correctly connected. Experiment with the phase switch settings. Also, adjust the crossover frequency by turning the crossover frequency control clockwise until the desired sound is achieved. Finally, if bass management is enabled on your receiver or processor, make sure to use the LFE line level input.
Guidance on positioning the subwoofer in the listening room for best bass response and balance.
Important notice on using a flat signal and setting up receiver bass management for accurate reproduction.
Ensures correct AC voltage setting to match local power for amplifier protection.
Addresses issues like power connection, audio signal, and blown fuse for no sound.
To Next Page
General