MORE PAD INDOOR
• semiconductor technopolymer, modulating and self-
regulating, with heating by the passage of electric current by
molecular vibration
• Can be installed on the floor, wall or ceiling.
• None
• Dry with a floating floor or glued to a desolidarising
sheathing.
• Other finishes on screed or fibre-reinforced levelling
compound
• System with electrical insulation class III SELV;
• Can be installed in the bathroom and shower compartment in
zone 1 as per IEC 64-8;
• The system does not generate electromagnetic phenomena during
operation
• Plastering with water-based cement mortar that can be smoothed over
reinforcement mesh;
• Ceramic wall tiles glued onto levelling compounds;
• Dry application of plasterboard;
• Integration of domestic heating systems;
• Heating of wet rooms (shower rooms, tepidarium, wellness areas,
etc.);
• Heating of rooms not served by air conditioning;
• Heating of rooms in discontinuous use with danger of frost;
• Heating of motor homes, caravans and boats;
• Heating of surfaces subject to fogging (mirrors in bathrooms,
wellness areas, etc.);
• Evaporation of water from internal walkways for anti-slip safety;
PAD INDOOR “IN BRIEF”
FUNCTIONL
PRINCIPLE
APPLICATION
INSTALLATION
ROUTINE
MAINTENANCE
FLOOR
FINISH
SAFETY
ELECTROMAGNETIC
COMPATIBILITY
WALL/CEILING
FINISH
To Next Page
Loading...