RCA 100 - Page 6

Fig.
6-Spacer
tool in place. upper
armature
end
Fig. 7-Spacer
tool in place,
lower armature end
Tightening upper
armature holding
screw
PART
III
Soldering the stylus to the thrust lever
'l'o
replace
a
defective cone:
1.
Remove
the small nut that holds
the
cone to the connecting
rod.
2.
Remove
the four
screws "a", "b", "c
and
"d" shown in Figure 13.
When
these
screws are removed
the entire
aluminum
frame
may be removed from the
casing. If
desirable, the
leads may
be disconnected, but
this
is
not necessary.
3. Remove
the remaining eight screws
shown
in Figure
13 as
"k"
and
"1".
J
4.
Remove
the outer clamping
ring.
5.
Remove
the cone.
8
www.americanradiohistory.com