Operating Remote Control
Before attempting to operate your
remote control, install the batteries as
shown here.
Your remote control is designed to be
very rugged and will withstand a
considerable drop. If it receives an
extreme blow, the case is designed to
slightly separate at the seam rather
than fracture. If this happens, simply
squeeze the case where it separated
until it snaps back together. The
operation of the remote will probably
not be affected. -
Helpful Hint:
The remote control produces an invisible
(infrared) beam thattravels in a straight
line much as the beam of a flashlight.
For this reason, when operating the
remote control, you must point it directly
atthe front of the TV Without objects
between that can block the infrared light
beam.
- Installing/Replacing Batteries
1. Turn the remote control face
down.
2. Press down on the ridged area of
the battery cover and slide it off.
3. install four "AAA" batteries in the
battery compartment as shown.
Make sureyou match the + end of
each battery to the + end of the
battery compartment.
4. Replace the cover and turn remote
over-face up.
Notes:
• Never place anything heavy on top of the
remote control or lay it upside-down.
This may accidentally depress the
buttons for a long time and discharge the
batteries.
• Replace the batteries when the TV fails
to respond to the remote control.
• If you programmed your remote to
control other components, you may have
to reprogram the code numbers when
you change batteries. Try not to press
any buttons while changing batteries.
6
To Next Page
Loading...
