Quick Guide to Your TV
Startup
3
A. Press MENU•PROG until the
Alarm menu is selected. This
menu is green.
B. The Clock is automatically
highlighted the first time you
set it. If it is not, press MOVE H
(down) to highlight it.
C. Press MOVE F to set the hour.
D. Press MOVE E to set the minutes.
A. Press MENU•PROG until the
Setup menu is selected. This
menu is white.
B. Press MOVE H to highlight
Autoprogram.
C. Press MOVE E to start placing
channels in the TV’s memory.
D. Wait until TV has cycled
through all the channels and
returns to original channel.
7. Set the time
6. Place all available
channels in memory
(AutoProgram)
Details for adding and deleting
channels are on page 20.
12:21 AM 13
Controls Alarm Adjust Setup
Alarm: Off
Alarm Channel: 07
On Time: Disabled
Off Time: Disabled
Clock: Use –/+ to set time.
13
Controls Alarm Adjust Setup
English
Français Español
Autoprogram
Label: 13 clear
Channel Memory: 13 Stored
Cable/Air: Cable
5. Adjust PICTURE TILT.
Picture tilt is used to correct a tilt-
ed picture from the effect of the
Earth's magnetic field on a large
picture tube. The PICTURE TILT
STRENGTH and POLARITY
switches on the back of the TV
compensate for this effect. If the
picture appears tilted, follow these
steps to improve it.
You may need to reset the switch-
es if the TV is moved or reposi-
tioned in the room.
OFF
PICTURE TILT
STRENGTH
+ –
POLARITY
HIGH
LOW
BACK OF TV
A. Make sure STRENGTH switch
is in the OFF position.
B. Move STRENGTH switch to the
LOW position. If this does not
fully improve tilt, move
STRENGTH switch to HIGH.
This should correct tilt. If
moving STRENGTH switch
makes tilt worse, return it to
OFF and go to the next step.
C. Change the position of
POLARITY switch. If this
improves the tilt but does not
fully improve it, move the
STRENGTH switch to LOW or
HIGH. This should correct tilt.
To Next Page
Loading...
Need help?
General
