The first step in connecting your TV is obtaining the signal. Your TV LED22B45RQD has a side panel, which allows you to receive
analog and/or digital television channels via ANT/CABLE jack.
Before connecting your TV, determine using an antenna or a cable service to obtain the signal.
A. Antenna
Connect the antenna to TV via coaxial cable on ANT/CABLE jack of the side panel. You are ready to receive air local digital and
analog channels.
B. Cable -rv service
Connect the cable TV wall jack to TV via coaxial cable on ANT/CABLE jack of the side panel. You are ready to receive off-air local
digital and analog channels.
C. Set-Top Box
Ifyou use a set-top box, you may need to call your cable company or satellite service provider, which use a special connection,
please refer to the user's guide of set-top box.
Note: Do not plug the AC cord until you have accomplished all the connections.
AC
100V-120V
50-60Hz
®
DDDDDDI!DDDDDDDDDDDD
o o
9_ L
Cable TV Antenna
OF
AC Power Cord
(Connect after all the other connections are done.)
10
To Next Page
Loading...
