RCA RCTC4GB

READ ME FIRST! Follow these steps to get started with your remote control.
Manually turn on the device you want to control.
Find the Code List that came with the
remote. Locate the section for the type of
device you’re trying to program, and nd
your brand in that section. Circle the codes
for your brand and keep them handy.
If you don’t see your brand listed, consult the
Owner’s Manual for other programming options.
1 2
3
VOLUME
VOLUME
CH+
0–
Test commonly used keys with the device (for example, POWER,
VOL+, CH+, and 0 for a TV).
If these keys work, congrats! You’ve nished programming
for this key! If not, try steps 4 and 5 with the next code for your
brand in the code list.
6
For more information, including instructional videos, remote programming codes, and
customer support, visit www.RCACodeSupport.com
To program the other device keys, follow these instructions again.
RCTC4GB QSG 00 R341U1
Press and hold the device key you want to
program for about 2 seconds, until the POWER
key illuminates and stays on. Then release the key.
4
5
Enter the rst ve-digit code for your brand
in the code list (the POWER key ashes after
each digit).
MENU
MENU
Plug the charging cable into
the charging jack on the
back/bottom of the remote.
Plug the other end into a
USB power source. The
red charging indicator
illuminates. The green
indicator illuminates when the
remote is fully charged.

RCA RCTC4GB Specifications

General

Brand	RCA
Model	RCTC4GB
Preprogrammed	Yes
Battery Type	AAA
Battery Quantity	2
Device Type	Remote Control
Batteries	Required
Supported Devices	TV, DVD
Compatible Devices	TV
Remote Control Technology	Infrared

Summary

Step 1: Charging the Remote

Charging Procedure

Connect the charging cable to the remote and a USB power source; observe indicator lights.

Step 2: Turn On Device

Manual Device Activation

Manually power on the device that the remote will control.

Step 3: Locate Programming Codes

Code List Usage

Find the Code List, locate your device type and brand, circle codes, and keep them handy.

Brand Not Listed

Consult the Owner's Manual if your brand is not found in the code list.

Step 4: Initiate Programming Mode

Device Key Programming Start

Hold the desired device key for 2 seconds until the POWER key lights up and stays on.

Step 5: Enter Programming Code

Five-Digit Code Entry

Input the first five-digit code; the POWER key will flash after each digit entry.

Step 6: Test and Finalize Programming

Key Function Testing

Test essential keys like POWER, VOL+, CH+, and 0 on the target device.

Programming Success or Retry

Verify key functionality; repeat steps 4-5 with the next code if unsuccessful.

Additional Resources

Visit RCACodeSupport.com for videos, codes, and customer support.