4
Other Keys (Listed Alphabetically)
Certain keys on the six-component universal remote
have dual functions. Primary functions are printed in
black. Secondary key functions are printed in blue on
the remote and are used for AUDIO operations.
0-9 (Number Keys): operate the same as number keys
on your original remote and are used to enter component
codes when programming the remote control with
Direct Entry method.
ANTENNA: in TV Mode, switches between the signal
coming from a satellite receiver or cable box and an
off-air antenna. In VCR Mode, switches between the
signal coming from a VCR and a TV.
CH+ and CH- (CHANNEL UP and CHANNEL DOWN):
goes to the next highest or lowest channel number in
the component channel list, respectively, except for
DVDs. In DVDs, the CH+ and CH- keys refers to the
NEXT/PREVIOUS chapter.
CLEAR: removes the on-screen display to return
to normal viewing.
CODE SEARCH: use to program the remote.
ENTER: use with Manual or Automatic Code Search
method to accept code (See Code Lists enclosed). Also, some
brands require you to press the ENTER key after you enter
a channel number. In some menu systems, you must press
the ENTER key to select a highlighted item.
GO BACK: switches back to previous channel– operates the
same as PREV CH, LAST CHANNEL or RECALL keys found
on some brands of remote controls.
GUIDE: brings up the on-screen TV program guide,
if your TV is equipped with that feature.
INFO: shows program information, if your component
is equipped with this feature. Functions the same as a
DISPLAY key.
INPUT: selects the video inputs of your TV, if equipped
with this feature.
MENU•PROG: accesses DVD disc menus when playing
a DVD disc. Accesses menu systems of some TVs, a few RCA
brand VCRs and satellite receivers. (For more information,
refer to the On-screen Menus section on page 12).
MUTE: lowers the TV’s volume to its minimum level.
NAVIGATION KEYS & SELECT: used to move through on-
screen menus and guides. Use the NAVIGATION keys to
move the highlighted choice up, down, left or right.
ON•OFF: turns component on and off.
Note: Some RCA, GE and PROSCAN models require that
you press the component
key to turn the component on and the ON•OFF key to turn the component off.
PIP: (Picture-in-Picture) and SWAP operate your TV’s Picture-in-Picture, if your
TV is equipped with this feature.
RECORD: use with VCR to record programming. You must press the RECORD key
twice to start recording.
SLEEP: allows you to set a time to turn off your TV automatically.
VOL: increases or decreases the TV or AUDIO system’s volume level.
Primary Key Descriptions For VIDEO Operations
To Next Page
Loading...
Need help?
General
