12
USING THE SCANNER
STORING SPECIFIC FREQUENCIES IN CHANNELS
You scanner is capable of storing up to 200 frequen-
cies via 20 channels in each of its 10 channel storage
banks.
To program frequencies:
1. Press MANUAL and wait for MAN to appear in the
display.
2. Enter the channel (1-200) into which you want to
program a frequency.
3. Press PGM and wait for it to appear in the display.
4. Enter the frequency of your choice, remembering
to include the decimal point when necessary.
5. Press ENTER to store the frequency.
6. Repeat Steps 2-5 to program additional channels.
NOTES: Should you make an incorrect entry,
Error will show in the display. Simply press the
CLEAR button and repeat Steps 4-5.
After entering the channels of your choice, the
scanner will automatically scan the most recently
stored channel.
DIRECT ENTRY
There are two ways to directly enter frequencies into
your scanner’s memory - limit and direct search.
LIMIT SEARCH
In this mode, the scanner will search up from a
selected lower frequency limit or down from a
selected higher frequency limit.
To begin a limit search:
1. Press the PGM button and then the LIMIT button.
Lo will appear on the display.
2. Key in the lowest frequency in the search range
and press the ENTER button.
To Next Page
Loading...
Need help?
General
