5
Operating the Clock
Waking by Selected Source
Programme
You may be woken up by music or alarm.
1. Select an AM or FM station. (refer to
“Tuning the Stations”)
2. Set wake time (see above direction).
3. Press the current setting alarm mode
(WAKE 1 or WAKE 2 to select waking
up by music or alarm. A green indicator
is up next to the selected setting.
4. Adjust the volume by turning VOLUME.
Note: When you turn off the alarm
or the radio by pressing ON/OFF, the
alarm or the radio will turn on at the
same time tomorrow.
Sleeping Mode
In sleeping mode, the radio will turn off
automatically. Simply:
1. Press SLEEP then the time display will
exhibit 0:59 and the radio will turn on.
2. While holding SLEEP, press REV or FWD
to set the sleep time. The time range is
from 1 minute to 2 hours.
3. Release SLEEP and the current time will
be shown again. The radio is turned
on and you may select the station as
usual. The radio will turn off when the
preset time elapses. If you decide to
turn off the radio sooner, press SNOOZE
or ON/OFF.
4. When SLEEP is activated again, the
sleep time will be the same as the one
you have set before.
5. Press SLEEP to read the remaining sleep
time.
Sleeping Mode and Waking
by Selected Source
Programme
You may set your digital clock radio to lull
you to sleep. The radio will turn off and
wake you up at the preset time.
1. Set the wake time.
2. Follow the steps under “Waking by
Selected Source Programme” and
“Sleeping Mode”.
1
2
AM
NAP
AM
53
60
70
85
110
170
kHz
FM
88
92
96
100
140
104
108
MHz
x10
RP3715 EN-US 6/21/01, 12:05 PM6
To Next Page
Loading...
Need help?
General
