2520 IB US ENG 1/12/00 3:36 PM Page 12
1. Press SOURCE to select TUNER.
2. Press BAND to select the next radio band.
Choices are:
AM/FM (RCA models)
FM/MW/LW (Thomson models)
The tuner can be either TUNE or PRESET mode.
When in PRESETmode, the PROG Iight is on,
desired frequency.
2.Pressthe SET button once,
3.The most recently accessedprogram location will
be displayed,
4. If adifferent program lOCationispreferred, rotate
MULTI JOG to move to the desired preset number (1-
32),
5.PressSETto store the selected frequency at that
preset.
Suppressing Stereo Signal
PressFM ST/SCAN to toggle between FM mono and
stereo for stereo FU stations,
Tuningto a Station
PressSKIP FORWARD/
BACKWARD to select fre-
quencies.
UsingPresets
Rotate MULTI JOG to accessthe previous or next pre-
set station. Thedisplay first shows the preset program
number and after afew seconds,the frequency and
then the preset program number again. (FMPR:01 is
FMpreset 1)
Thomson models
Tip: RDS _tatiorl9_t OA _4
o_ly. _l I_ t_ de_ts arl
RDS si_, _im RE_ io_s t_
Q-
Auto Preset Programming (for FAll
only)
Pressand hold BAND
button for 2 second to
scan stations in the select-
ed band. Thestations will
then be stored aspreset
channels, Maximum 32 stations can be stored, Beware
of your preset channels being erased accidentally
becausethe scanning and storing process isautomatic
upon pressing the button.
You can stop the automatic scan by pressing any but
ton, but the erased stations cannot be recovered.
Setting Presets
1. PressSKIP FORWARD/BACKWARD to accessthe
Tuningto an RDSStation
1. Rotate MULTI JOGto preset station or pressSKIP
FORWARD/BACKWARD to desired frequency,
2. If RDSstation found, RDS Iights on display with sta-
tion name shown.
"÷.... .............................................................................................................................................................................. ..÷"
8
To Next Page
Loading...
Need help?
General
