38
Appendix A: Connecting the Receiver
Position cables correctly to avoid
audio hum or interference
• Insert all cable plugs firmly into their jacks.
• Place audio/video cables to the sides of the
receiver’s back panel instead of straight down the
middle after you connect the components.
• Try not to coil any power cables and keep them
away from the audio/video cables as much as
possible.
• Make sure all antennas and cables are properly
grounded. Refer to the Safety Tips sheet packed
with your receiver.
Protect your components |
from overheating
• Do not block ventilation holes in any component.
Arrange the components so that air can circulate
freely.
• Do not stack components directly on top of each
other.
• Allow adequate ventilation when placing your
components in a stand.
• Place an amplifier near the top shelf of the stand so
heating air rising from it will not flow around other
components. If you have a satellite receiver, you
should place it on the top shelf.
To Next Page
Loading...
Need help?
General
