3
POWER SUPPLY
USING THE AC ADAPTER
Using an AC adapter other than the one supplied with the unit may damage the unit.
Caution:
• Before use, ensure the rated voltage of the adapter matches your local voltage.
• The included AC adapter is for use with this unit only. Do not use it with other equipment.
• If you are not going to use the unit for a long time, disconnect the AC adapter from the wall outlet.
• Whenever the AC adapter is plugged in to a wall outlet, the AC adapter will draw some power, even
when the Sound Bar is turned off.
USING THE REMOTE CONTROL
• Point the remote control at the REMOTE SENSOR located on the unit (see Front Panel illustration for
precise location).
• When there is a strong ambient light source, the perform ance of the infrared REMOTE SENSOR may be
degraded, causing unreliable operation.
• The recommended effective distance for remote operation is about 16 feet (5 meters).
BATTERY REPLACEMENT
When the batteries become weak, the operating distance of the remote control is greatly reduced and you
will need to replace them.
Notes:
• If the remote control is not going to be used for a long time, remove the batteries to avoid corrosion
damage caused by battery leakage.
• Do not mix old and new batteries. Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable
(NICKEL-CADMIUM) batteries.
• Always remove batteries as soon as they become weak.
• Weak batteries can leak and severely damage the remote control.
• WARNING: Do not dispose of batteries in a fire. batteries may explode or leak.
CAUTION:
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
REMOTE CONTROL
TO CHANGE REMOTE BATTERIES
1. Open the battery door. 2. Insert two AAA batteries.
To Next Page
Loading...
Need help?
General
