12
Assigning The AUX Button
You can assign any one of the following devices to the AUX button:
Audio Components (CD Player, Amplifier, Receiver, Tape Deck, Phonograph), Laser Disc Player or
a second TV, VCR, Satellite or Cable Box.
BLINK/ON
________________
INDICATOR
LIGHT
OFF
1. Manually turn on the device you wish to control.
2. Press and hold the CODE SEARCH button until
the Indicator Light lights, then release the
CODE SEARCH button.
3. Press and release the AUX button
(the Indicator Light will blink then remain lit).
Then press the button for the device you want to
program (TV, VCR, SAT) (Press SAT for a Cable Box).
4. Find the three digit code for your device in the brand
list and enter it using the Number Buttons.
TV Codes page 6-7
VCR Codes page 8-9
Satellite Codes page 10
Cable Box Codes Page 11
Audio Codes Page 13
After your code is entered, the Indicator Light will
turn off.
5. Aim the remote at the device you wish to control and
press the POWER button. The device should turn off.
Note: If your device does not respond, try all the codes for your
brand. If the codes do not work, or your brand is not listed, try
the Code Search method on page 14.
6. With your device on, press CHANNEL UP. If it
responds, no further programming is required.
7. Enter your code and the type of device you
programmed here for easy reference.
To Next Page
Loading...
Need help?
General
