The included remote is a universal type which has to be configured for a Sony
TV. You can in fact use any universal remote programmed for a Sony TV. You
must also have the TV button pressed to tell the remote to use TV codes. Most
universal remotes can control several devices such as a TV, VCR, and DVD.
You want to set the remote for a TV.
To use the remote point it towards the TVHOSC unit. There is an IR receiver
mounted in the center, on one end, on the unit (See below). You will soon
discover that the remote signals will bounce off the ceiling and walls and will
easily find their target (the TVHOSC unit).
SETTING the TIME DELAY
A variable resistor control is located on the main circuit board. This blue control
sets the time delay or the amount of time that power gets applied to a switch.
If power is applied to a switch for too long then the switch gets hot and may even
eventually start to melt. If power isn’t applied long enough the switch will not
operate correctly. You want to find the mid-point.
To Next Page
Loading...
