RCRCM DG600 - Page 5

For the fu
For the fuFor the fu
For the fuselage servos, fist remove the horn of the servo (if the hor
selage servos, fist remove the horn of the servo (if the horselage servos, fist remove the horn of the servo (if the hor
selage servos, fist remove the horn of the servo (if the horn is on
n is on n is on
n is on
the servo), then connect
the servo), then connectthe servo), then connect
the servo), then connect with
withwith
with the wiring harness, and install the servo in
the wiring harness, and install the servo in the wiring harness, and install the servo in
the wiring harness, and install the servo in
the servo plate.
the servo plate.the servo plate.
the servo plate.
7
77
7：
：：
：将推拉杆⼀侧的铁夹头扣上舵机摇臂后
将推拉杆⼀侧的铁夹头扣上舵机摇臂后将推拉杆⼀侧的铁夹头扣上舵机摇臂后
将推拉杆⼀侧的铁夹头扣上舵机摇臂后，
，，
，从垂直尾翼顶部的孔中
从垂直尾翼顶部的孔中从垂直尾翼顶部的孔中
从垂直尾翼顶部的孔中穿⼊
穿⼊穿⼊
穿⼊，
，，
，然
然然
然
后
后后
后将舵机摇臂安装在舵机上
将舵机摇臂安装在舵机上将舵机摇臂安装在舵机上
将舵机摇臂安装在舵机上。
。。
。
Connect
ConnectConnect
Connect the horn of servo with the clevis,
the horn of servo with the clevis, the horn of servo with the clevis,
the horn of servo with the clevis, then install the horn on the
then install the horn on the then install the horn on the
then install the horn on the
servo.
servo.servo.
servo.