Need help?Do you have a question about the RCRCM Hornet Motor Glider and is the answer not in the manual?
Setting the initial elevator position for best glide angle using V blocks and incidence.
Adjusting aileron control rod length for 90-degree servo horn alignment.
Setting flap travel to 5mm up and 75-80 deg down, adjusting control arm angle.
Planning flight modes for launch, normal, loiter, and landing using Sanwa SD-10G radio.
Performing glide tests to evaluate flight characteristics and initial CG.
Conducting the first powered flight to test climb away and handling.
Control throws and presets for launch mode including rates and elevator/rudder trim.
To Next Page
General
