ENGLISH
2
All steps in these assembly instructions should be completed on a clean, non-abrasive
surface. Steps and procedures in these assembly instructions assume the use of the
included Boerboel
®
Gate Hardware Kit (hinges and latch).
– Safety Goggles
– Tape Measure
– Level
– Hacksaw or Chopsaw
– Rubber Mallet
– Drill
– Drill Bits
– #2 Square Drive Bit
– Spacer Blocks
TOOLS NEEDED:
GATE KIT
Warning: Always wear safety goggles.
GATE KIT COMPONENT LIST:
Check the kit to ensure all components are included.
A) 2½" x 2½" x 36" or 42" Aluminum
Uprights – 2
B) Telescoping Metal Support Brace – 2
C) Allen Wrench for Hinges – 1
D) 1" Phillips Screws (for hinges) – 8
E) Hinges – 2
F) Gravity Latch – 1
G) 1" Phillips Screws (for latch) – 6
H) #8 x ³/
8
" Screws (For metal braces) – 4
I) #8 x ¾" Screws (For metal braces) – 4
J) #10 x 1" Screws – 4
A
B
C
E
F
D
G
I
J
H
Need a little help installing your railing?
www.rdirail.com/support/installation-videos.html
Read all instructions prior to installing product.
Refer to local building codes for installation requirements; failure to install this product in
accordance with building codes may affect safety of the product and void product warranty.
Refer to manufacturers safety instructions when operating any tools.
To Next Page
Loading...