Rduch MWL-9DSP1A - Jack connector pin configuration; Amplifiers menu control; Menu structure and navigation

ENTER
EXIT
ENTER
EXIT
Gain
gain regulation -30dB ¸ +6dB
0 dB
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT
Delay
EQ
FBS
Limiter
Noise gate
Preset
Options
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT
delay line 0 ¸ 500 ms;
units [m],[cm],[ms]
15- pointed parametric or shelf equalizer
-12dB/+12dB; 0,05 ¸ 3oct, 20 Hz ¸ 21kHz,
LoSh6, LoSh12, HiSh6, HiSh12.
digital feedback eliminator
adapting method or phase shifter method
- limiter with regulated reaction time: slow,
medium, fast; regulated level of operation (+6dB –40dB)
- noise gate, turn on level regulation
(90dB ¸ -24dB)
preset:
writing the preset´s name
options: turning on the password
0 ms
0.0
-80 dB
EQ 1
Peak
9k50 1.50
FBS : on
Adaptive
Gain
Delay
Limiter
Slow OFF
Noise gate
Preset: Name
ENTER
EXIT
Preset: Name
choice: Name Preset,
beginning settings,
copying preset.
Name preset: 1
ENTER
EXIT
Godow
few people
preset´s name edition
Options: Password
choice: Password, language
(polish, english)
ENTER
EXIT
Options: Password
Passwort: yes
6
4b. Jack pin connection:
hot (+ve)
colt (-ve)
chassis/ grounding
chassis/ grounding
chassis/ grounding
signal´s input
terminal
ring
sleeve
SYMMETRICAL
terminal
ring
ASYMMETRIC
Connection of 0 dB input and output 0 dB
For the feedback eliminator, the equalizer, the expander
– compressor, the delaying line to be connected
INSERT SOCKET
coming back of the signal
chassis/ grounding
signal´s output
sleeve
5. Amplifier’s menu control..
After amplifier’s connection to 230V currency by a given cable and power input (switch no 15), our company’s logo
appears, and after several seconds, there is a note: “MWL Control” “Preset 1” ( or “Preset 2”).
For the display menu control, there is a pulser’s handwheel ( 7 ) – to come into the settings mode – press it. Then,
there is a next note – “Gain”.
Turning the handwheel left or right, there are other menu’s parts ( previous or next parts). To come into the chosen
part – press handwheel ( 7 ) (ENTER).
To come back to the previous part – press ( EXIT) ( 9 ).
Menu structur