CLEANING AND MAINTENANCE
En
EPA Pleated Filter Removal and/or Replacement
• Push the two protrusions of the EPA Filter inwards and pull it out. Install the
new Pleated EPA Filter to the position.
• Do not discard the Seal Ring when replacing the filter. Please install it on
the new filter “required”; otherwise, it will reduce vacuuming efficiency.
• The filter life depends on the usage frequency.
• NEVER vacuum without all filter components installed. Motor damage will incur
and void unit warranty.
Two protrusions
Power Brush Maintenance
When the lint, string, hair etc. are stuck in the power brush, an overload safety
measure is activated, the LED will flash “RED”, and the unit will shut down in
about 10 seconds. Please remove and clean the brush as instructed below.
Regular Bristle Cleaning
• Turn off the machine and release the floor brush.
• Rotate the power brush by hand. Remove any hair/string on the brush.
Floor Brush (Bottom)
Bristle Brush
To Next Page
Loading...