This "How to" is written as a general guide on how to use your ReadyNet AC1200MS with
PBXware 5.3.1.0. It covers the most common tasks required in order to have your ReadyNet
AC1200MS working efficiently.
Requirements
1. Identify ReadyNet device
To start and successfully complete registration of your ReadyNet device you need to know
■
which device model you will setup.
From the back of each ReadyNet device there are exact model information that you should
■
check. Although different device models can have exactly the same requirements and
installation procedure, device models can also have significantly different requirements and
installation procedure, so that ignorance of your own model may result in the inability to
successfully set up your device.
2. ReadyNet AC1200MS firmware.
- Make sure that device is loaded with 3.20 firmware.
3. DHCP server.
- Fully configured and operational DHCP server.
Installation
This chapter describes how to install and connect the device to the electrical power and data
network as well as how to apply factory settings.
The following topics are covered:
To Next Page
Loading...
