Fitting Trim to Firebox
Fit the trim to the firebox. The trim brackets are designed to hang over the flange on
the front of the firebox. The flange has provision to be moved slightly in or out to
allow the bracket to fit. The flange on each side of the firebox has a raised square near
the base of the fire. The Velcro pad is fixed to this, by removing the backing from one
side of the pad and pushing firmly in place. Then remove backing from other side.
Repeat on opposite side. Hang trim on brackets and check for level then push firmly
onto Velcro pad.
Check that the fire is operating correctly and test for spillage of products of
combustion.
Instruct user
Once the installation is complete, instruct the user on the operation of the fire and
complete commissioning details in Real Fires user manual.
All installations must be Certified
To Next Page
Loading...
