2700 Oak Industrial Drive NE Grand Rapids, MI 49505 USA 800.253.1561 • www.kv.com
©2018 Knape & Vogt. All rights reserved. Reservados todos los derechos. Tous droits réservés.
310622//0318
Pullout Cabinet Organizer
Installation Instructions
Inspect all parts and read all instructions prior to beginning assembly and installation.
Now that the front mounting strap is mounted to the cabinet
oor drill pilot holes in through the rear mounting hole
locations with the 1/16" drill bit. Fasten the rear mounting
strap to the cabinet oor using two mounting screws. Push
the multi-use basket all the way back into the cabinet.
Installation is now complete.
Tools Required
• Phillips Head Screwdriver
• Drill with 1/16" (1.5mm) bit for
drilling pilot holes
Sliding Basket Assembly (1) Mounting Screws (4)
Parts Included
Product Assemblies
RS-MUB-11-FN
RS-MUB-14-FN
RS-MUB-17-FN
Installation
2
Pull the multi-use basket completely forward. Place the
entire assembly back inside of the cabinet so that the
front mounting holes line directly over the pilot holes
you drilled in the cabinet oor. Fasten the front mounting
strap to the cabinet oor using two mounting screws.
3
1
Place the sliding basket assembly in cabinet at desired
location. With a pencil mark the cabinet oor through the
front two mounting hole locations. Remove the basket from
the cabinet. With 1/16" drill bit drill pilot holes through the
two mounting hole locations you marked.
1-1/4"
(3.2 cm)
Pullout Cabinet Organizer
Installation Instructions
Inspect all parts and read all instructions prior to beginning assembly and installation.
To Next Page
Need help?
General