PREPARATION FOR USE
I N S T A L L I N G T R A N S M I T T E R / R e c e i v e r C o n n e c t i o n s
M I C R O P H O N E B A T T E R Y
Install two AA batteries in each tran
smitter. For longest battery life, we
recommend alkaline batteries (Radio
Shack Cat. No. 23-552).
1. Open the transmitter's battery com
partment cover by pressing it in the
direction of the arrow and iifting it up.
Follow these steps to connect your
1. Be sure the POWER switch is set to
off and the VOLUME controls are set
to minimum.
2. Instail the AA batteries observing the
polarity (-t-and—) symbols marked
in the battery compartment.
3. Close the battery com partment cover.
The BATTERY indicator lights when
battery power is low. Use fresh re
placement batteries of the same type.
C a u t i o n : N e v e r l e a v e w e a k o r d e a d
b a t t e r i e s i n s i d e t h e t r a n s m i t t e r . E v e n
leak-proof batteries can ieak damaging
chemicais.
2. Use a shielded audio connector
cable with standard RCA phono
plugs. Connect the receiver's LINE
jack to the line-or aux-input of your
PA amp, tape recorder, mixer, or
other input component.
To Next Page
Loading...