26/02/2013
Reader “Memory” function
The V8 reader has a memory enabling it to store 1000 identifiers (tag numbers).
This function must be activated by the user if he wishes to use it.
Storage of numbers read by the V8 reader
The V8 allows the user to store the numbers of the tags read in order to transfer them
subsequently to a PC using the USB cable included with the reader.
To use this function, you must first activate the “Memory” function (see block diagram:
“Memory 1”).
Each time a new tag is read, the reader displays the number but if the same tag is read twice by
mistake the reader indicates this by emitting a characteristic beep and displaying “DUP” on the
right of the screen.
This number will not be stored a second time.
If the reader is switched off, the memory function will still be activated when it is switched on
again.
Deactivating the memory
The memory can be deactivated via the “Memory” menu.
Two cases may arise:
First case:
- Numbers are recorded in the reader’s memory (Block diagram: Memory 3)
In this case you must transmit the list of recorded numbers actually or virtually (without
plugging in the USB cable) and then erase them (see Block Diagram: Memory 2)
Second case:
The memory has been previously activated but no number has been recorded.
In this case simply “deactivate” the memory (block diagram: “Memory 2”
Erasing the memory
To erase the contents of the memory to avoid errors, you must select the “Memory” menu and
transmit the list of recorded numbers actually or virtually (without plugging in the USB cable)
and then erase them (see Block Diagram: Memory 3).
To Next Page
Loading...