Need help?Do you have a question about the Recoil RED600.1 and is the answer not in the manual?
Covers operational safety, impedance limits, ventilation, and moderate volume usage.
Guidelines on amplifier placement, ventilation, accessibility, and secure mounting.
Instructions for safe electrical connections, including battery disconnect and grounding.
Details on connecting the main power supply and using a fuse for protection.
Procedure for establishing a secure, low-resistance ground connection to the chassis.
How to connect the remote turn-on wire for amplifier activation.
Guidance on connecting speaker cables to the output terminals and checking impedance.
Connects Left/Right channel signal input from source unit using RCA cables.
Connects to another amplifier for multi-amplifier systems.
Adjusts input gain to match source unit output levels for optimal performance.
Removes unwanted sub-sonic frequencies below tuning frequency to protect woofer.
Adds 0 to +9dB boost at 45Hz; use cautiously with some subwoofer systems.
Selects the crossover point for the low pass filter, adjustable between 35-250 Hz.
Port for remote level control, allowing user adjustment from driver's seat.
Lights indicate power status and protection faults; Protect LED indicates a problem.
Connects Left/Right channel signal input from source unit using RCA cables.
"Pass Thru" for mono block amplifier, simplifies connection in Front/Rear/Sub system.
Allows amplifier to be driven with either 2 or 4 pairs of inputs.
Adjusts input gain to match source unit output levels for optimal performance.
Selects crossover point for high pass filter, adjustable between 15-350 Hz.
Selects crossover type (HPF, LPF, FULL) for different speaker frequencies.
Selects crossover point for low pass filter, adjustable between 35-350 Hz.
Adds 0 to +12dB boost at 45Hz; use cautiously with some subwoofer systems.
Lights indicate power status and protection faults; Protect LED indicates a problem.
Illustrates how to connect RCA audio cables from the head unit to the amplifier.
Shows how to connect speaker wires from the amplifier to the speakers.
Technical details including RMS power, frequency response, and dimensions for all models.
Steps to diagnose and resolve issues where the amplifier produces no audio output.
Guidance on fixing audio distortion or unwanted noise from the amplifier.
Tips for addressing issues related to weak or inadequate bass output.
General| Channels | 1 |
|---|---|
| Minimum Impedance Unbridged | 2 Ohms |
| Signal to Noise Ratio | >90 dB |
| Subsonic Filter | 10Hz - 50Hz |
| Bass Boost | 0 - 12 dB |
| Bass Boost Frequency | 45Hz |
| Amplifier Class | D |
| Input Sensitivity | 0.2V - 6V |
| RMS Power @ 2 Ohms | 600W x 1 |
| Frequency Response | 10Hz - 180Hz |
| Fuse Rating | 40A |
To Next Page
