Recon Scout XT - Water-Resistant XT Robot Guide; Ensuring Robot Watertightness

©2011 ReconRobotics
1
Recon Scout Inventory
Recon Scout Inventory
Please inspect the inventory in this package to ensure that all materials are present.
If any of the materials are missing, please contact support@reconrobotics.com for
further assistance.
Your Recon Scout® Robot Kit includes:

One (1) Recon Scout Robot
One (1) Recon Scout Robot Charger
One (1) Recon Scout Operator Control Unit (OCU)
One (1) Recon Scout OCU Charger
One (1) Carrying Case
One (1) User’s Manual
One (1) Spare Activation Key
One (1) Lanyard
One (1) Warranty Card
One (1) Battery Charge Indicator
In addition, the Recon Scout XT Kit contains:

One (1) Tether Cord
One (1) Lens Cover Sticker Replacement Kit
Double Recon Scout Kits will also include:

One (1) Additional Recon Scout Robot
One (1) Additional Recon Scout Robot Charger
©2011 ReconRobotics
10
Water
Water
-
-
Resistant XT Instructions
Resistant XT Instructions
This Recon Scout® XT and Rescue robots have enhanced water resistance capabilities,
which means that it can be safely driven through puddles, used in heavy rain, or briefly
submerged in water. Please review the following guidelines for using and maintaining
your Recon Scout XT or Rescue robot.
HOW TO MAKE THE ROBOT WATERTIGHT
Deployment:
1. Check that the plug band is properly seated in the charging port.
2. Pull pin to activate robot.
3. Plug pin hole (press on the bump to fully seat).
4. Confirm that both the pin and charge ports are sealed.
5. Deploy robot.
After Deployment:
1. Towel dry the robot and OCU.
2. Unplug pin hole.
2. Reinsert pin to deactivate robot.
4. Replace lens cover if seal is peeling or scratched.
5. Push down antenna boots if they are coming loose.
Charging:
1. Pull out plug to charge.
2. Replace the plug after charging is complete.
ADDITIONAL MAINTENANCE GUIDELINES

The OCU is not waterproof so exposure to moisture should be minimized.
Do not remove any screws on the robot; this may unseat the gaskets.
To replace cover, follow instructions included in bag of spare covers and
alcohol swabs.
The robot should never be submerged intentionally.
Remove from water as soon as possible after submersion.