Recon 264342 Series - User Manual

To Next Page

RECON Truck Installation Guide for 264342 Series

Cab Lights

This kit is for trucks that currently do not have any cab light installed on the truck.

First, you will need to measure and mark the roof per the measurements on the second page of this

guide. Once, you have the measurements marked, you will need to drill small pilot holes for each of the

screws on the lights. Then drill a 1/4” hole for the wiring and plug to fit into the roof.

The wire harness will have a positive wire and a ground wire. The positive wire will need to be

connected to any running light positive source on the truck. Most newer Superduty trucks have a 4 pin

connector at the footwell area below the A pillar that has this running light wire(even if the truck has no

OEM cab lights). This is where we recommend making the power connection, but any running light

source will work(and make your new RECON cab lights turn on with the headlights). You can connect

the ground wire directly to the body of truck.

Need help?

Do you have a question about the Recon 264342 Series and is the answer not in the manual?

Summary

Measure and mark roof, drill pilot holes for screws and a 1/4" hole for wiring and plug.

Connect positive wire to running light source and ground wire to truck body.

Diagram showing placement measurements for RECON cab lights on the truck roof.

Measure and mark roof, drill pilot holes for screws and a 1/4" hole for wiring and plug.

Connect positive wire to running light source and ground wire to truck body.

Diagram showing placement measurements for RECON cab lights on the truck roof.

General