6.
Do not let go of the oven control knob, keep the oven control knob
pushed in and hold the oven control knob in for 5 seconds after the
pilot light is lit. If needed, repeat steps 4 and 5 if the gas range oven is
not lit.
7.
Adjust the burner to the desired flame level by rotating the oven
control knob left and right. (Fig. 16)
0
Lighting Electronically:
1.
Make sure and check that ALL knobs are turned to the OFF position
before lighting.
2.
Ensure the main gas valve is in the open position.
3.
Push and rotate the oven control knob counterclockwise to the
light position. (Fig. 14)
4.
Continue to push and hold in the oven control knob for 5 seconds and
rotate the ignition button clockwise repeatedly until the burner lights.
Repeat steps 3 & 4 if not lit. (Fig. 17)
5.
Adjust the flame to the desired level by rotating the control knob.
16IPage
To Next Page