EasyManua.ls Logo

RectorSeal AG-4200E - User Manual

RectorSeal AG-4200E
5 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
LIMITED WARRANTIES AND LIMITATION OF
LIABILITY
REGISTER YOUR PRODUCT ONLINE: www.rectorseal.com
1 YEAR SWITCH AND SENSOR LIMITED WARRANTY AND LIMITATION OF LIABILITY
The limitations of liability set forth below include body and all component parts as well as the product itself as a whole.
Rectorseal warrants to the original consumer purchaser (“Purchaser) of its AquaGuard switch and sensor products, that they are free from
defects in material or workmanship for a period of one (1) year from the date of purchase. If this product shall prove to be defective within the
one (1) year period from the date of purchase, it shall be repaired or replaced, at Rectorseal ‘s option, subject to the GENERAL TERMS and
CONDITIONS set forth below.
EXCLUSIONS
This warranty does not cover damages resulting from use of components or accessories not approved by Rectorseal. 3, and 10 YEAR SEC-
ONDARY DRAIN PAN LIMITED WARRANTY AND LIMITATION OF LIABILITY
This warranty applies only to secondary drain pans installed in the United States and Canada.
Rectorseal warrants to the original consumer purchaser (“Purchaser”) of its AquaGuard secondary drain pan products, that they are free from
defects in material or workmanship for a period of three (3) years for Titan pan models, ten (10) years for Goliath and Goliath Furnace
models, from the date of purchase. If this product shall prove to be defective within the three, five or ten (3, or 10) year period from the date of
purchase, it shall be repaired or replaced, at Rectorseal’s option, subject to the GENERAL TERMS and CONDITIONS set forth below. This
warranty extends only to the original consumer purchaser and is nontransferable.
EXCLUSIONS
This warranty does not cover damages resulting from the use of corrosive material (including, but not limited to: Acetone, MEK and
petro-leum-based products); nor damages resulting from use of components or accessories not approved by Rectorseal.
GENERAL TERMS AND CONDITIONS
To be eligible for the warranty the purchaser must provide Rectorseal with the following:
1. Proof of Purchase (Original Receipt)
2. Installer’s Testimony
3. Original Product
4. Original Work Order
5. Photos of Installation
PURCHASER MUST PAY ALL LABOR AND SHIPPING CHARGES NECESSARY TO REPLACE PRODUCT COVERED BY THIS WAR-
RANTY. This warranty shall not apply to acts of God, nor shall it apply to products which, in the sole judgment of Rectorseal have been subject
to negligence, abuse, accident, tampering, misapplication, alteration; nor due to improper installation, operation or maintenance or storage; nor
moved from its original place of installation; nor to other than normal application, use or service, including but not limited to, operational failures
caused by corrosion, rust or other foreign materials in the system. Requests for service under this warranty shall be made by returning the de-
fective product to the Retail outlet or to Rectorseal as soon as possible after the discovery of any alleged defect. Rectorseal will subsequently
take corrective action as promptly as reasonably possible. No requests for service under this warranty will be accepted if received more than
thirty-one (31) days after the term of the warranty.1hiswarranty sets forth Rectorseal’s sole obligation and purchaser’s exclusive remedy for de-
fective products. For your benefit and protection register your product online at www.rectorseal.com within thirty (30) days of installation. This
will initiate the Warranty period and will allow us to contact you, should it become necessary. In the absence of a recorded product registration,
the Warranty period will begin upon product shipment from Rectorseal. In the event that Rectorseal attempts to contact consumers regarding a
recall or other matter, and any damages occur, which could have been avoided by registration by the consumer, Rectorseal shall have no
liability. IN ALL CIRCUMSTANCES, RECTORSEAL’S MAXIMUM LIABILITY SHALL NOT EXCEED THE ACTUAL PURCHASE PRICE
PAID FOR THE PRODUCT ALONE. Warranty claims must be registered with Rectorseal within thirty (30) days of damage or malfunction.
Rectorseal reserves the right to visit the site of the installation or to require documentation of the claim before assuming any responsibility
under the provisions of this Warranty.Consumer agrees to inspect the product at the time of installation for any reasonable discernable defects
and, further, agrees to inspect the product annually. Any damages occurring, which could have been avoided by proper inspection will not be
the responsibility of Rectorseal. RECTORSEAL SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INCIDENTAL, OR CONTINGENT
DAMAGES WHATSOEVER TO THE PURCHASER OR ANY THIRD PARTY.THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN
LIEU OF ALL EXPRESSED WARRANTIES. IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL NOT EXTEND BEYOND THE DURATION OF THE APPLICA-
BLE EXPRESSED WARRANTIES PROVIDED HEREIN.
Some states do not allow the exclusion of limitation of incidental and consequential damages or limitations on how long an implied
warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may also
have other legal rights that vary from state to state. VENUE: Any purchaser or third party actions brought for any reason hereunder shall be
commenced in Houston, TX and no other jurisdiction, and such action shall be governed by and construed in accordance with the laws of the
State of Texas. Any notice herein shall be sent by certified or registered mail to 2601 Spenwick Drive, Houston, TX USA
RectorSeal® Houston, TX USA www.rectorseals.com US Patent Pending
In HVAC Unit locate H
A. Connect “RED”, “Input 24 VAC (Hot)” and “Gray” “Common” wire of AG-4200E to 24
VAC (Hot) secondary side of 24 VAC Transformer.
C
o
m
ú
n
-
G
R
I
S
C
o
m
m
o
n
-
G
R
A
Y
*Note:
Probe Wire Not Included
On Model AG-1250E
Figure 1
AG-4200E to
AG-4200E to
AG-4200E
AG-4200E
NOTE: When AG-4200E is wired correctly, the HVAC unit will shut-off upon condensate detection.
ATTENTION: Clean surface with included alcohol pad before mounting with adhesive tape.
Installation Instructions
Wiring the AquaGuard
®
AG-4100E, 4200E or 4300E - Water Sensor and Drain Port
AG-4100E
AG-4200E
AG-4300E
ATTENTION: Clean surface with included alcohol pad before mounting with adhesive tape.
Installation Instructions
Wiring the AquaGuard
®
AG-4100E, 4200E or 4300E - Water Sensor and Drain Port
AG-4100E
AG-4200E
AG-4300E
ATTENTION: Clean surface with included alcohol pad before mounting with adhesive tape.
Installation Instructions
Wiring the AquaGuard
®
AG-4100E, 4200E or 4300E - Water Sensor and Drain Port
AG-4100E
AG-4200E
AG-4300E
ATTENTIÓN:
AG-4200E to
Question and Answer IconNeed help?

Do you have a question about the RectorSeal AG-4200E and is the answer not in the manual?

Summary

WIRING DIAGRAM FOR BREAKING WALL THERMOSTAT POWER WIRE

Thermostat Power Wire Connection Steps

Detailed steps for connecting AG-4200E wires to HVAC thermostat power circuit.

Testing the AG-4200 E Secondary Pan Sensor

Procedure to test the sensor and confirm HVAC unit shut-off upon condensate detection.

OPTIONAL WIRING DIAGRAM FOR BREAKING COMPRESSOR WIRE

Compressor Wire Connection Steps

Detailed steps for connecting AG-4200E wires to HVAC compressor circuit.

Testing the AG-4200 E Secondary Pan Sensor

Procedure to test the sensor and confirm compressor unit shut-off upon condensate detection.

SENSOR PORT SIGNAL CONNECTIONS

Normally Closed Signal (A)

Wiring diagram for connecting to sensor port using a normally closed signal.

Normally Open Signal (B)

Wiring diagram for connecting to sensor port using a normally open signal.

DRAIN FITTING AND SENSOR INSTALLATION

Sensor Carrier Installation

Steps for installing the drain housing and sensor carrier with thread nut and gasket.

TITAN Drain Pan Installation

Titan Pan Installation Instructions

Instructions for inspecting and installing Titan drain pans, including support methods.

GOLIATH VALUE, GOLIATH FURNACE Horizontal Drain Pan Installation

Goliath Horizontal Drain Pan Installation

Instructions for installing Goliath Value/Furnace horizontal drain pans, including support and clearance.

GOLIATH FURNACE DRAIN PAN VERTICAL INSTALLATION

Goliath Furnace Vertical Pan Installation

Instructions for installing Goliath Furnace vertical drain pans, including vibration isolators.

IMPORTANT SAFETY AND OPERATIONAL NOTES

Specifications, Warnings, and Recommendations

Details on relay specs, installation compliance, electrical hazards, system backup, and sensor maintenance.

LIMITED WARRANTIES AND LIMITATION OF LIABILITY

1 Year Switch and Sensor Limited Warranty

Rectorseal's limited warranty for AquaGuard switches and sensors for one year from purchase date.

3 and 10 Year Secondary Drain Pan Limited Warranty

Rectorseal's limited warranty for secondary drain pans for three or ten years from purchase date.

General Terms and Conditions for Warranty

Conditions for warranty eligibility, claims, exclusions, and liability limitations.

Summary

WIRING DIAGRAM FOR BREAKING WALL THERMOSTAT POWER WIRE

Thermostat Power Wire Connection Steps

Detailed steps for connecting AG-4200E wires to HVAC thermostat power circuit.

Testing the AG-4200 E Secondary Pan Sensor

Procedure to test the sensor and confirm HVAC unit shut-off upon condensate detection.

OPTIONAL WIRING DIAGRAM FOR BREAKING COMPRESSOR WIRE

Compressor Wire Connection Steps

Detailed steps for connecting AG-4200E wires to HVAC compressor circuit.

Testing the AG-4200 E Secondary Pan Sensor

Procedure to test the sensor and confirm compressor unit shut-off upon condensate detection.

SENSOR PORT SIGNAL CONNECTIONS

Normally Closed Signal (A)

Wiring diagram for connecting to sensor port using a normally closed signal.

Normally Open Signal (B)

Wiring diagram for connecting to sensor port using a normally open signal.

DRAIN FITTING AND SENSOR INSTALLATION

Sensor Carrier Installation

Steps for installing the drain housing and sensor carrier with thread nut and gasket.

TITAN Drain Pan Installation

Titan Pan Installation Instructions

Instructions for inspecting and installing Titan drain pans, including support methods.

GOLIATH VALUE, GOLIATH FURNACE Horizontal Drain Pan Installation

Goliath Horizontal Drain Pan Installation

Instructions for installing Goliath Value/Furnace horizontal drain pans, including support and clearance.

GOLIATH FURNACE DRAIN PAN VERTICAL INSTALLATION

Goliath Furnace Vertical Pan Installation

Instructions for installing Goliath Furnace vertical drain pans, including vibration isolators.

IMPORTANT SAFETY AND OPERATIONAL NOTES

Specifications, Warnings, and Recommendations

Details on relay specs, installation compliance, electrical hazards, system backup, and sensor maintenance.

LIMITED WARRANTIES AND LIMITATION OF LIABILITY

1 Year Switch and Sensor Limited Warranty

Rectorseal's limited warranty for AquaGuard switches and sensors for one year from purchase date.

3 and 10 Year Secondary Drain Pan Limited Warranty

Rectorseal's limited warranty for secondary drain pans for three or ten years from purchase date.

General Terms and Conditions for Warranty

Conditions for warranty eligibility, claims, exclusions, and liability limitations.

RectorSeal AG-4200E Specifications

General IconGeneral
BrandRectorSeal
ModelAG-4200E
CategoryAccessories
LanguageEnglish

Related product manuals