- Open the locking hook on the side of the chassis and raise the handlebar (1 and 2).
- When using for the first time, attach the seat straps around the chassis. Don't make
them too tight. (3).
WARNING: Make sure that the handlebar is firmly in place (click heard).
1. UNFOLDING
FRONT WHEEL
- The stroller comes with the front wheel fitted.
- To remove it, unscrew the plastic caps from the front wheel axle, then unscrew the
screws from both sides of the axle (4).
REAR WHEELS
- Both wheels will block into place automatically. Both wheels will block into place
automatically (click heard) (5).
- To remove them, pull on the grey lever, removing the wheel at the same time (6).
2. WHEELS
- Pushing down on the horizontal bar with your foot will lock the rear-wheels (7).
WARNING: Check that the wheels are firmly locked.
- To unlock, lift up the horizontal bar with your foot (8).
3. PARKING BRAKES
FRONT WHEEL SWIVEL OR FIXED
SWIVEL POSITION:
- Lift up the foot rest (see FOOT REST paragraph) then,
- Lift up the lever lock located below the foot rest to lock it in place (9).
FIXED POSITION:
- Lower the lever lock as shown (10).
WARNING: This product is not suitable for running or skating.
WARNING: The swivel wheel allows greater manoeuvrability of the stroller. Over
rough grounds (sand, snow, stones, mud…), it is strongly recommended that the front
wheel be used in the fixed position.
THE SEAT BACK
- The seat back has 3 positions: sitting, reclining and lying down. To change positions
just open the 2 (or 4) zips on either side of the seat back.
PLEASE NOTE! The zips must be fully opened in order to avoid breaking them.
4. ADJUSTMENTS
43
GB
To Next Page
Loading...
