REMOVABLE, ADJUSTABLE BUMPER BAR
HOW TO ATTACH THE BUMPER BAR:
- Detach the seat flaps from the chassis by undoing the press studs. Position the
bumper bar at the places provided on either side of the chassis. Position it in place,
push on it, it clips into place. (24).
SECURING IT IN PLACE:
- Secure the brackets in place (click heard) (25).
- Close the press studs.
It is height adjustable.
- Press on the buttons at the side, keep them pressed to the required height then
release them (click heard) (25a).
SAFETY STRAP
- It is essential to use the safety strap when on steep slopes.
- Attach the safety strap around the axle situated between the two rear wheels (never
round the stroller handlebar) (26).
- Put the other end around your wrist (27).
- When you are not using the safety strap, attach it in a loop over the handlebar (use
the 2 Velcro strips) (28).
WARNING: Always use the safety strap when on steep slopes.
SEAT CUSHION (Optional)
It is reversible (one cotton side and one fleece side).
- Slip the straps of the safety harness and the crotch strap through the slits in the
cushion (29). Secure the cushion in place with the Velcro bands located behind the
back of the seat (30).
BASKET
- For easy access, open the zip fastenings on either side (31). Detach the Velcro
fastenings to remove it.
WARNING: The maximum load in the basket should not exceed 5 kg.
WARNING: The maximum load in other compartments should not
exceed 0, 5 kg.
WARNING: Only use compartments provided for storage and do not go over and
above the recommended weight.
WARNING: Empty the basket completely BEFORE folding the stroller.
PROTECTION AGAINST COLD, WIND AND RAIN
- Unfold the rain cover and place it on the hood.
- Fasten with the Velcro strips as shown (32a, b, c).
5. ACCESSORIES
45
GB